Easy to Apply, Here’s How to Jumper the Starter Bendix to Start the Engine
A machine that won't start makes many people panic, often taking the practical route by asking for help to push it.
However, there is an easier way to do this, which is to perform a jump start. This jumper starter method only requires another battery to supply electricity. Let's check the review here!
Things to Consider
An important point that you must not overlook is to pay attention to the voltage of the battery used.
Make sure the other battery has the same capacity as the battery installed with the starter motor. This way, it can maintain the durability of the motor dynamo you have.
The owner of this machine must connect the batteries in parallel, so the connected battery circuit is positive to positive.
Likewise, the negative terminals should also be connected, so they are not arranged in series to avoid voltage accumulation. If the voltage increases, it can damage the starter motor system and others.
Read also: Causes of Car Dynamo Starter Damage!
Easy Way to Perform a Jump Start
The first method uses another battery as an alternative power supply, so an additional battery is needed.
This jumper starter method should start by opening the car hood. After that, clean the battery terminals if there is dirt that could interfere with the jump start process.
Then, prepare the battery outside the engine system and connect the same poles to the battery terminals in your vehicle. This parallel installation connects negative to negative and positive to positive.
Next, ensure the car's transmission is in neutral and the parking brake is engaged so that the engine does not run.
The next step is to start the engine until it runs. Slowly, you can disconnect the cable connecting the negative battery to the vehicle's battery.
Also, disconnect the clamp cable and valve at the positive terminal, then tidy up the cables and the used battery and close the car hood.
Easy Way to Perform a Jump Starter with Another Machine
The previous jumper starter method used a battery, but this time it is slightly different as it requires another machine.
You can use another vehicle as a power supply, so it needs to be positioned close together. After that, the hoods of both cars should be opened first to connect.
The installation remains in the same position, namely in parallel so that the voltage does not increase. You can connect the positive terminals of the dead vehicle with the assisting vehicle, as well as the negative terminals.
Don't forget to position the transmission in neutral and the parking brake on. After that, start the car engine until it runs so it can be used and driven.
Once it is running, you can disconnect the cables used in this car jumper starter method, starting from the negative terminal then the positive. The final step is to tidy up the cables used and the vehicle battery, then close the hood of your four-wheeled vehicle.
Read also: Easy Tricks to Maintain Car and Motorcycle Starter Dynamo
